I finished off fitting the seat cover today. I had left the glue to dry overnight on the foam.
This morning I heated the vinyl cover and stretched it into position, held in place by clips. I left it like this for half an hour to settle and then I re-tensioned the cover before gluing it into final position.
Job done. I think it turned out well, considering the mess it was to start with.
This morning I heated the vinyl cover and stretched it into position, held in place by clips. I left it like this for half an hour to settle and then I re-tensioned the cover before gluing it into final position.
Job done. I think it turned out well, considering the mess it was to start with.
Then it was back to the 750 to fit the front brake light switch to the new switchgear. The thread for the switch is at an angle but the metal casting does not compensate for this so I marked it out and filed it until I got the right profile.